M12 Holder for Milwaukee Packout Locking Foot

M12 Holders for Locking Foot

Description

This M12 battery holder is meant to attach to the top of the Milwaukee Packout locking foot. This allows you to store a battery in any of the open square spaces on top of a Packout. Simply twist the holder in place and snap in a battery.

Files

Printer: Prusa i3 MK3
Slicer: Cura Slicer
Material: Inland PET-G
Resolution: 0.3mm layer height with a 0.4mm nozzle
Wall Lines/Perimeters: 3
Infill: Minimum 10% Gyroid. The higher infill percentage the stronger the part.
Notes: No supports needed.

Instructions

The M12 battery holder fits into the into the top of the gear shaft on the Packout locking foot. It uses a single panhead #8-32 3/4″ machine screw to permanently stay attached to the locking foot. Just make sure you’ve pressed the 8-32 nut into the gear shaft on the locking foot first.

2 comments

Leave a Reply

Your email address will not be published. Required fields are marked *