Description
These hangers allow you to mount the same 2″ aluminum bar that I used in the Packout rail bar on your wall or pegboard. Many different things can be hung from this bar including tools with belt clips, Packout bins, and special clip mounts I made to fit this size bar.
Files
Print Settings
Printer: Prusa i3 MK3
Slicer: PrusaSlicer
Material: Inland PET-G
Resolution: 0.3 mm with a 0.4mm nozzle
Wall Lines/Perimeters: 3
Infill: Minimum 10% Gyroid. The higher infill percentage the stronger the part.
Notes:
Instructions
Parts needed:
- Two 3D printed end hangers
- A middle hanger for every 12″ of bar or so
- 2″ x1/8″ aluminum bar cut to length (see below)
- #8×1/2″ pan head screws
- 4×1 pegboard screw anchor for each hanger if using 1/4″ pegboard
The length of the bar should be the distance between the holes at the holder ends plus 3/8″.
In pegboard you need to use some sort of anchor to attach the hangers. You can use wall anchors (which tend to spin), or my special pegboard screw anchors listed above.
