ToughCase+ Small Box Bracket

ToughCase+Medium Box Holder both Edge and Side Mount

Description

These brackets are designed to hold the small Dewalt ToughCase+ accessory box. They will also work with the very similar Craftsman accessory boxes, but the fit is much tighter.

I designed them to be used with my Packout rail bar clips which mount on the  2″ Packout rail mount bar. They can also be wall or pegboard mounted.

I’ve included a single STL file that has a 1″x1″ hole pattern on both the end and the back so it can be mounted flat or sideways.

Files

Printer: Prusa i3 MK3
Slicer: PrusaSlicer
Material: Inland PET-G
Resolution: 0.3 mm with a 0.4mm nozzle
Wall Lines/Perimeters: 3
Infill: Minimum 10% Gyroid. The higher infill percentage the stronger the part.
Notes:

Instructions

Printing this can be a little finicky, I’ve noticed that the fit is looser with 2 perimeters than 3. If you are going to adjust the model or the print parameters, I’d wait an hour after the print is cooled.

2 comments

Leave a Reply to Benjamen Johnson Cancel reply

Your email address will not be published. Required fields are marked *